Table of Contents
Advertisement
1.
Attach the plow onto the truck by driving
the truck prongs into the receivers on the
plow frame.
Pull the latch handle into the frame clevis
to move sliders through the notches in the
prongs and receivers. Pin the handle in the
clevis with its klik pin.
Raise the parking stand to its highest posi-
tion and repin.
SYSTEM CHECKOUT
DWG. NO. 5691
DWG. NO. 5696
2.
Connect the electrical cables from the plow
to their corresponding receptacles on the
truck. Validate the power connection is red
stripe to red stripe and black to black.
3.
Select Hiniker Cold Flow Hydraulic Oil or
an equivalent oil that meets military speci-
fication 5606, for plowing in extremely cold
temperatures.
Pour hydraulic oil into the power unit oil
reservoir until the reservoir is half full.
Angle the plow full left or right with the cab
control box inside the truck to fill the an-
gling cylinder with oil. Add more oil until the
reservoir is about 3/4 full. Do not over-fill
the reservoir.
Cycle the plow left and right and up and
down to purge any air trapped in the hy-
draulic system.
Check the oil level with the plow on the
ground. Add oil to the fill line, if necessary,
but do not over fill the reservoir.
NOTE: New hydraulic cylinders will leak a small
amount of oil until packings become saturated
and produce a good seal. If leakage is exces-
sive, or if leaking continues after initial cycling,
tighten the cylinder packing nut in 1/8-turn in-
crements until leaking stops.
System Checkout 11
DWG. NO. 6697
Advertisement
Table of Contents
