Lincoln Electric K2751-1 Operator's Manual page 11

A-4
4. Using a phillips screwdriver and 12 sheet metal
screws, mount the dust cover plates to the dust
collection tray. See Figure A.3.
Figure A.3 - DUST COVER PLATES
x12
Fig. III
5. Using a 10mm wrench and six bolts, mount the
backdraft panel to the dust collection tray. See
Figure A.4.
Figure A.4 - BACKDRAFT PANEL
Fig. IV
INSTALLATION
A
x6
DOWNFLEX
6. a. Using a 13mm wrench, install the four side panel
hinges onto the backdraft panel.
b. Using a 13mm wrench, fasten the two side pan-
els (left and right) to the hinges previously
mounted to the backdraft panel. See Figure A.5.
Figure A.5 - HINGE and PANEL MOUNTING
Fig. V
Side Panels
7. Carefully place the two work grids on the dust col-
lection grid. Secure using ground clamps if applic-
able. See Figure A.6.
Figure A.6 - WORK GRIDS
A
Fig. VIII
TM
A-4
Hinges
B