Table of Contents
Advertisement
HORIZONTAL INSTALLATION
Use the paper template, and trace the position of the two fas-
tening brackets and the two rear screws on the ceiling.
Drill the holes with a suitable drill bit and insert the anchors (2
for each bracket); fasten the two brackets.
Do not fully tighten the screws.
Insert the unit on the two brackets, holding it in position, then
tighten the two screws in the rear anchors, one on each side.
Leave the unit sloping down towards the drain pipe so as to
assist drainage.
Then completely tighten all 6 fastening screws.
A anchors
B brackets
C screws
D drain pipe
FIXING THE FRONT INTAKE GRILL (MODELS DLMV, DLMO, DLRV)
To prevent the grill from being accidentally removed or left
detached from the quick connectors provided and therefore
causing the fan coil to malfunction (in this case the fan stops
and the grill safety alarm is shown), two screws are supplied
that are used to secure the grill in place.
These are 4.2x9.5 mm socket head screws.
A louver with holes to be inserted into the
guide
B fixing screws
C position of guide connection louver
A
B
D
B
A
For installation of DLMO versions, the horizontal condensate
collection pan kits are available as accessories.
DLRV versions must not be installed horizontally.
Carefully check the slope of the drain pipe.
If the drain line is not sloping downwards, water may
leak from the line.
A
B
Simply screw these into the holes provided on the grill con-
nection louvers, as shown in the figure.
C
C
EN FDL3-i SLIM
I A
I A
11
Advertisement
Table of Contents
