Advertisement
D
Tip over switch
E
Filter protection grille
F
Filter
USE
Installation
The appliance can be used on any horizontal surface.
Do not overload the electrical circuit. Avoid using the same
socket for other appliances.
Electrical connection
Before plugging into the mains, make sure the voltage of
your mains supply corresponds to the value V indicated on the
appliance and that the socket and power line are appropriate
for the load required.
Operation and use
1. Make sure the selector (A) is in the "0" position before
plugging the appliance into the mains socket.
2. Plug into the mains socket.
3. Turn the appliance on by placing the thermostat (B) in
the Max position and the mode selector (A) in one of the
following positions:
The following modes are available:
-
Summer mode (fan only): turn the mode selector to the
position (the light comes on).
-
Low power operation: turn the mode selector to posi-
tion "1".
-
Medium power operation: turn the mode selector to
position "2".
-
High power operation: turn the mode selector to posi-
tion "3".
-
To turn the appliance off: turn the mode selector to the
"0" position and the thermostat to the
unplug from the mains.
Adjusting the thermostat
When the room has reached the required temperature, turn
the thermostat (B) slowly anticlockwise until you hear a
"click". The thermostat will then keep room temperature at
the selected level automatically.
Frost prevention mode
With the thermostat dial at minimum
lector (A) on "3", the appliance maintains room temperature
at about 5°C, preventing freezing with minimal energy con-
sumption.
/1/2/3.
position, then
and the mode se-
SAFETY DEVICE
A safety device shuts the appliance down in the case of
overheating. To start the radiator up again, contact Customer
Experience. See enclosed guarantee leaflet.
MAINTENANCE
-
Always unplug from the mains socket before cleaning.
-
During the season when the appliance is in use, clean
the air intake and outlet grilles regularly using a vacuum
cleaner.
-
To clean the filter, remove the rear grille (E) by pulling
it outwards. Remove the dust filter (F) which retains
impurities in the air drawn in from the room, blow on it
lightly then replace in the appliance.
-
Never use abrasive powders or solvents to clean the ap-
pliance.
TECHNICAL CHARACTERISTICS
Supply voltage
Absorbed power
6
See rating plate
"
Advertisement
