Cleaning The Photocells; Automatic Energy Saving; Disposing Of The Machine - Intimus 205 SP2 Operating Manual

USA
1 Oil hose
2 Cap
3
Oil container
fig. 6 Oil container
2 . Release the screw cap (fig. 6/2), take the oil hose
with the screw cap out of the empty container and
remove the container.
3 . Suspend the full container and remove the screw
cap. Feed the oil hose (fig. 6/1) into the container
and close the container again with the screw cap
that is connected to the oil hose.
4 . Press the reverse button (fig. 2/5).
¾ The control display (fig. 2/5) goes out.
5 . Close the door.
¾ The control display
¾ The control display (fig. 2/7) goes out.
The machine is ready for use again. Should you need
to re-order the special oil see „Accessories", p. 18.

5 .3 Cleaning the photocells

fig. 7 Cleaning the photocells
If paper particles should come to rest in the inlet gui-
de (for example after a paper jam) it is possible that
the machine will not turn off, due to the broken light
barrier.
To remove these paper strips and also to clean the
photocell, pass another sheet of paper through the
feed slot, or switch the machine off and wipe both
"eyes" of the photocell with a brush (fig. 7).
95611 1 02/19
1
2
3
000080
(fig. 2/6) goes out.
000155

5 .4 Automatic energy saving

If the machine is not used for a while it automatically
switches off after about 15 minutes. The function but-
ton (fig. 2/1) LED display
the function button briefly to turn it on again.

5 .5 Disposing of the machine

Dispose of the machine in an environmen-
tally friendly fashion at the end of its useful
service life. Do not dispose of any of the parts
included in the machine or its packaging with
household waste.
205 SP2/CP4/CP5/CP6/CP7
for "Ready" goes out. Press
9