Maintenance/Disposing; Cleaning The Photocells; Cutting System Maintanance; Energy Saving Tip - Intimus H200 CP4 Operating Instructions Manual

GB
NOTE!
The machine will only run with closed door!
4

Maintenance/Disposing

4 .1 Cleaning the photocells

(Abb . 4)
If paper particles should come to rest in the inlet gui-
de (for example after a paper jam) it is possible that
the machine will not turn off, due to the broken light
barrier.
To remove these paper strips and also to clean the
photocell, pass another sheet of paper through the
feed slot, or switch the machine to reverse and wipe
both „eyes" of the photocell with a brush.

4 .2 Cutting system maintanance

After about 2 hours of continuous operation run the
cutting system in reverse for about 30 seconds and, at
the same time, spray some of the enclosed special oil
onto the cutting system.

4 .3 Energy saving tip

Be certain that the machine is turned off overnight
(mains switch (fig. 2) switched to „0").

4 .4 Disposing of the machine

Dispose of the machine in an environmentally
sound fashion at the end of its useful service
life. Do not dispose of any of the parts inclu-
ded in the machine or its packaging with
household trash.
82810 18 07/21
5

Malfunction

5 .1 Taking out excess paper in case
of overload
If the shredder has stopped due to an overload (motor
protection) take the excess paper out of the inlet as
follows:
1 . Depress the reverse pushbutton (fig. 3/1). The ma-
terial is released.
2 . Lift up the hopper. The pilot lamp „door open" or
„hopper open" (fig. 3/6) will light.
3 . Remove the excess material by hand from the inlet
guide.
NOTE!
In this case, there is no danger of injury as all
circuits are interrupted when the hopper is lif-
ted and the machine cannot be started.

5 .2 Motor fault

The machine is equipped with a thermally protected
motor. Should this motor be overloaded, it will switch
off automatically. In such case the pilot lamp „ready"
(fig. 3/4) flashes. Additional the pilot lamp of the con-
trol display (fig. 3/6) lights up.
After a cooling down period of approx. 10 minutes (de-
pending on the room temperature) you can restart the
machine and continue shredding.

5 .3 Fault checklist

If the machine is not functioning properly, you should
check the following:
• is the plug conneted to the mains?
• is the mains switch (fig. 2) turned on?
• is the door closed?
• is the collecting bag full?
¾ The bag has to be emptied.
• is the motor overloaded?
¾ Please refer to the section headed „Motor Fault".
• is there a phase failure?
¾ Check the three-phase fuse at the power supply
socket, and replace if necessary.
NOTE!
In many cases, restarting the machine helps:
1 . Switch off the machine once.
2 . Turn the machine on again.
If you still cannot isolate the fault after carrying out all
these checks, please notify our customer service de-
partment.
200 CP5 / H200 CP4
13