Cleaning And Maintenance - Whirlpool OMSR58RU0SX Quick Manual

CLEANING AND MAINTENANCE

Make sure that the oven has
cooled down before carrying out
any maintenance or cleaning.
Do not use steam cleaners.
EXTERIOR SURFACES
Clean the surfaces with a damp microfibre cloth. If they are
very dirty, add a few drops of pH-neutral detergent. Finish
off with a dry cloth.
Do not use corrosive or abrasive detergents. If any of
these products inadvertently comes into contact with the
surfaces of the appliance, clean immediately with a damp
microfibre cloth.
INTERIOR SURFACES
• After every use, leave the oven to cool and then clean it,
preferably while it is still warm, to remove any deposits or
stains caused by food residues. To dry any condensation
that has formed as a result of cooking foods with a high
water content, leave the oven to cool completely and then
wipe it with a cloth or sponge.
• To remove the remaining limescale from the bottom of
the cavity after the
to clean the cavity with the products provided by After
REMOVING AND REFITTING THE DOOR
1.
To remove the door, open it fully and lower the
catches until they are in the unlock position.
2.
Close the door as much as you can.
Take a firm hold of the door with both hands – do
not hold it by the handle. Simply remove the door by
continuing to close it while pulling it upwards (a) at
the same time until it is released from its seating (b).
Put the door to one side, resting it on a soft surface.
REPLACING THE LAMP
1. Disconnect the oven from the power supply.
2. Unscrew the cover from the light, replace the bulb and
screw the cover back on the light.
3. Reconnect the oven to the power supply.
8
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
cooking, we recommend
Wear protective gloves.
The oven must be disconnected
from the mains before carrying
out any kind of maintenance
work.
Sales Service (please follow instructions attached to the
product).
Cleaning is recommended at least for every 5 to 10
cooking cycles.
• If there is stubborn dirt on the interior surfaces, we
recommend running the automatic cleaning function
for optimal cleaning results. Avoid activating the pyrolitic
cycle cleaning in the presence of limescale residues. Before
activating, perform limescale cleaning as described above.
• The door can be easily removed and refitted to facilitate
cleaning of the glass.
• Clean the glass in the door with a suitable liquid
detergent.
ACCESSORIES
Soak the accessories in a washing-up liquid solution after
use, handling them with oven gloves if they are still hot.
Food residues can be removed using a washing-up brush
or a sponge.
~60°
3.
Refit the door by moving it towards the oven,
aligning the hooks of the hinges with their seating
and securing the upper part onto its seating.
4.
Lower the door and then open it fully.
Lower the catches into their original position: Make
sure that you lower them down completely.
5.
Try closing the door and check to make sure that it
lines up with the control panel. If it does not, repeat
the steps above.
Please note: Use 25 W/230 V type G9, T300 °C halogen lamps.
The bulb used in the product is specifically designed for
domestic appliances and is not suitable for general room
lighting within the home (EC Regulation 244/2009).
Light bulbs are available from our After-sales Service. - Do not
handle bulbs with your bare hands as your fingerprints could
damage them. Do not use the oven until the light cover has
been refitted.
~15°
b
a