Table of Contents
Advertisement
Unpacking and Removing Shipping
Bolts
Remove the washer from the carton base.
If you must lay the washer down to remove the
base packaging materials, always lay it carefully on
its side. Do not lay the washer on its front or back.
1
Starting with the bottom two shipping bolts,
use the wrench (included) to fully loosen all four
shipping bolts by turning them counterclockwise.
Remove the bolt assemblies by wiggling them
slightly while pulling them out.
2
Locate the four hole caps included in the
accessory pack and install them in the shipping
Carton Base
bolt holes.
y Save the bolt assemblies for future use. To
prevent damage to internal components, do
not transport the washer without reinstalling
the shipping bolts.
y Failure to remove shipping bolts and retainers
may cause severe vibration and noise, which
can lead to permanent damage to the washer.
The cord is secured to the back of the washer
with a shipping bolt to help prevent operation
with shipping bolts in place.
Cap
NOTE
13
INSTALLATION
Advertisement
Table of Contents
