Table of Contents
Advertisement
MODELSPECIFICATIONS
Triggering source
Coupling
Slope
Sensitivity
Triggering modes
TRIGGERING
EXT Triggering Signal Input
Input Impedance
Max. Input Voltage
Sweep Time
Sweep Time Accuracy
Vernier Sweep Time Control
HORIZIONAL
Sweep Magnification
AXIS
×10MAG Sweep Time Accuracy
Linearity
Position shift caused by ×10MAG
Sensitivity
Frequency Bandwidth
X-Y MODE
X-Y Phase Difference
Sensitivity
Test Equipment Depot
www.testequipmentdepot.com
CH1, CH2, LINE, EXT (CH1 and CH2 can be selected only in the DUAL or ADD vertical mode).
In ALT mode, if the TRIG. ALT switch is pushed in, it can alternate triggering of two different
source.
AC: 20Hz to full bandwidth.
+ / -.
20Hz 〜 2MHz : 0.5 DIV, TRIG-ALT:2 DIV, EXT : 200mV.
2 〜 20MHz
TV : Sync pulse more than 1 DIV (EXT: 1V).
AUTO : Sweeps run in the free mode when no triggering input signal is applied.
(Applicable for repetitive signals of frequency 25Hz or over.).
NORM : When no triggering signal is applied, the trace is in the ready state, but is not displayed.
TV-V
: This setting is used when observing the entire vertical picture of television signal.
TV-H
: This setting is used when observing the entire horizontal picture of television signal.
(Both TV-V and TV-H synchronize only when the synchronizing signal is negative)
Approx.: 1M ohm // approx. 25Pf.
300V (DC+AC peak), AC: Frequency not higher than 1kHz.
0.2μSec 〜 0.5 Sec/DIV, 20 steps in 1-2-5 sequence.
±3%.
≤1/2.5 of panel-indicated value.
10 times
±5%, (20nSec〜50nSec are uncalibrated).
±3%, ×10MAG:±5% (20ns and 50ns are uncalibrated).
Within 2 div. at CRT screen center.
Same as vertical axis (X-axis:CH1 input signal; Y-axis:CH2 input signal.).
DC to at least 500kHz.
0
≤3
at DC 〜50kHz.
5 Vp-p (Positive-going signal decreases intensity).
99 Washington Street
Melrose, MA 02176-6024
800-517-8431
GOS-620 20MHz OSCILLOSOPE
: 1.5 DIV, TRIG-ALT:3 DIV, EXT : 800mV.
3
781-665-0780 FAX
Advertisement
Table of Contents
