Off-Season Storage; Belt Replacement - Tarmo XTP121 Instruction Manual

Off-Season Storage

Refer to the Engine Manual for information
on storing your engine.
At the end of the season or if the snow blower will
not be used for 30 days longer, follow the storage
instructions below.
1. Run the engine until the fuel lines and
carburetor are empty and it stops due to lack
of fuel.
2. Remove the safety ignition key and allow the
engine to cool.
3. Lubricate the machine as instructed.
4. Clean the exterior of the engine and the snow
blower thoroughly.
5. Touch up all rusted or chipped paint surfaces;
sand affected areas before painting, and use
a rust preventative to prevent the metal parts
from rusting.
6. Tighten all loose screws, bolts, and locknuts.
Repair or replace any damaged parts.
7. Cover the machine and store it in a clean, dry
place out of the reach of children.
SERVICE

Belt Replacement

Auger Belt
If the auger belt becomes worn, oil-soaked, or
otherwise damaged, proceed as follows to replace
the belt.
1. To prevent spillage, remove all fuel from tank
by running engine until it stops. Remove the
key to avoid unintended starting and allow unit
to cool completely.
2. Remove the two screws that hold the belt
cover in place and set the cover aside
3. Roll the auger belt(s) off the engine pulley.
4. Carefully pivot the snow blower up and
forward so that in rests on the auger housing.