Tarmo XTP121 Instruction Manual page 73

ASSEMBLY
Following the assembly directions below, you will
assemble the snow blower in a few minutes
Handlebars
Before installing the handlebars, ensure that all
the cables run directly and logically.
1. Position the lower handle against the left and
right sides of the machine. Align the holes in the
handle with the side plates and secure lower
handle with the screws and the washers until they
are finger tight.
2. Keep the lower handle level and tighten all four
screws.
3. Raise the handlebars into operation position
and secure the handlebars with M8X45 screws,
washers and nuts until they are finger tight.
4. Ensure that the handles are at the same height,
and then tighten the fasteners securely.
Tires
The tires are over-inflated at factory for shipping
purposes. Check the pressure in the tires. Reduce
or increase equally in both tires to the
manufacturer's recommended pressure.
Under any circumstance do not exceed
manufacturer's recommended pressure.
Excessive pressure when seating beads
may cause tire/rim assembly to burst with
force sufficient to cause serious injury.
Refer to side wall of tire for recommended
pressure.
Equal tire pressure should be maintained
at all times. If the tire pressure is not equal
in both tires, the machine may not travel in
a straight path and the shave plate may
wear unevenly.
Keep tires free of gasoline and oil, which
can harm rubber.