Adapter Basic Diagnostics - TRENDnet TE100-PCBUSR User Manual

have to be resolved manually by a CMOS Setup utility
run after you have reinstalled all of the expansion cards.
The Diagnostic Program provides two levels of testing:
Adapter Basic Diagnostics and Network Diagnostics.
Adapter Basic Diagnostic does not require substitution of
a loopback cable.
may be carried out with the network cable connection in
place.
For the Network Diagnostics, the cable connecting your
station with its supporting hub/switch must be in place.
Network Diagnostic involves "broadcast" transmission of
test packets from the initiator station. The test cannot be
fully implemented unless a responder station on the LAN
is available to the Network Diagnostics, in order to return
the test packets to the initiator station.
To run the Diagnostic Program, proceed with these
steps:

Adapter Basic Diagnostics

1. Insert the 32-bit CardBus 10/100Mbps
Ethernet PC Card driver CD in an available drive
(here shown as drive D). At the DOS prompt (here
shown as >), key in:
> D: \Rset\ENCBRSET.BAT and <Enter>.
The opening screen of the Diagnostic program will
appear.
2. Review the reported configuration data before
All procedures of the Adapter test
Fast