Installing Your Powerline Adapters; Before You Install; Connect A Powerline Adapter To Your Router - TRENDnet TPL-430AP User Manual

TRENDnet User's Guide

Installing your Powerline Adapters

Before you Install

1. Before you proceed with the installation, verify the following:

You already have a router already installed.

You already have Internet access through your existing network.

An Ethernet port (also called LAN port) is available on your router.

Verify that you have at least two Powerline adapters. You will need at least
two Powerline adapters to create a Powerline network.
Note: The TPL-430AP package only includes a single Powerline adapter. The
TPL-430APK package includes TPL-423E and TPL-430AP to create your
Powerline network. Please ensure that your other Powerline adapter is
HomePlug® AV or IEEE 1901 compliant (e.g. TRENDnet models TPL-406E, TPL-
407E, TPL-408E, TPL-410AP, TPL-420E, TPL-421E, TPL-422E, TPL-423E, or
another TPL-430AP.)
2. Plan the location of where you will install your Powerline adapters.

Avoid plugging the adapters into power strips, extension cords, or surge
protectors as this may prevent the adapter from functioning correctly or
degrade performance.

Avoid plugging the adapters into wall power outlets that are controlled by a
light switch to prevent the Powerline adapter from being turned off
accidentally.

Avoid plugging the adapters into wall power outlets that are located near
appliances that consume a lot of power (e.g. refrigerators, washers, dryers) as
this may degrade performance.

Make sure there is an available wall power outlet in the room where the router
is installed and also near the router.

Make sure there is an available wall power outlet in the room where you want
to extend network connectivity.
© Copyright 2017 TRENDnet. All Rights Reserved.

Connect a Powerline adapter to your router

1. Plug the Powerline adapter into an available wall power outlet near your router.
Note: This will allow devices connected to your Powerline network to access the Internet
and other devices connected to your network.
2. Connect the included Ethernet cable (also called network cable) from the Ethernet
port (also called network port) of your Powerline adapter to an available Ethernet port
(also called LAN port) on your router.
3. Once the Powerline adapter is installed and connected to your router, verify that the
Power LED is on or blinking and the Ethernet LED is on or blinking.
TPL-430AP / TPL-430APK
14