Vissani QR254 Series Owner's Manual page 11

Installation (continued)
NOTE:
This range hood can be installed to the cabinet with or without the use of the
supplied installation brackets.
A. INSTALLATION WITHOUT MOUNTING BRACKETS
If you are installing this range hood to a framed cabinet install a 3
the range hood can be securely tightened to the cabinet.
position. Mark the location of the four keyhole mounting slots (1) on
the underside of the cabinet.
Set the range hood (A) aside on a protective surface.
Drill four pilot holes in the locations that you marked.
Screw the four long tapping screws (AA) into the pilot holes.
Do not tighten the screws all the way – leave the screw
heads about 0.28 in (7 mm) from the cabinet surface.
Lift the range hood (A) into position, feeding the power
cable and the electrical wires through the power access
opening. Allow some slack in the cable and wires so that the
appliance can be moved if servicing is ever necessary.
Position the range hood (A) so the large end (2) of the
keyhole mounting slots (1) are over the screws (AA). Then
push the range hood (A) toward the wall so the screws (AA)
are in the neck (3) of the keyhole slots. Tighten the screws
(AA). Ensure that the range hood (A) is securely fastened to
the cabinet before releasing it.
If applicable, test the damper to ensure it rotates up and
down freely.
If applicable, connect the duct work to the range hood (A).
B. INSTALLATION USING 1 PERSON INSTALL BRACKETS
B.1 FRAMELESS CABINET BRACKET INSTALLATION
Refer to the marking on brackets to determine the correct
installation side and orientation.
Flat end of the bracket with the arrow should face towards
you and the notched end should face the wall.
Please contact vissani@conglom.com or 1-888-449-9197
Turn off the power circuit breaker or the
power switch on the junction box before installing this
unit. Touching circuitry inside the range hood while it is
energized will result in death or serious injury.
If installing this unit over a gas range, turn off the
gas at the source before installing or servicing this unit.
11
Fig. 15
Fig. 16