Table of Contents
Advertisement
Installation
Adjusting the feet
If the door of the product cannot be closed
properly or if the product swings when you
push it slightly, then you need to adjust
the feet of the product. Adjust the feet of
the product as illustrated in the installation
manual supplied with the product.
A
Dishwashers door must be
aligned properly otherwise hot
steam can escape! Danger of
serious burns, other injury or
may damage furniture.
Electrical connection
Connect the product to a grounded outlet
protected by a fuse complying with the
values in the "Technical specifications"
table. The manufacturer shall not be liable
for any damages that will arise when the
product is used without grounding in
accordance with the local regulations.
Connection must comply with national
•
regulations.
Power cable plug must be within easy
•
reach after installation.
B
Unplug the product after the
washing programme is over.
Dishwasher / User's Manual
The voltage and allowed fuse or
•
breaker protection are specified in the
"Technical specifications" section. If the
current value of the fuse or breaker in
the house is less than 16 Amps, have
a qualified electrician install a 16 Amp
fuse.
The specified voltage must be equal to
•
your mains voltage.
Do not make connections via extension
•
cables or multi-plugs.
B
Damaged power cables must
be replaced by the Authorised
Service Agent.
B
If your dishwasher is equipped
with internal illumination, lamp
should only be replaced by the
Authorised Service Agent in
case of failures that may occur
on the lamp.
B
If the product has a failure, it
should not be operated unless
it is repaired by the Authorised
Service Agent! There is the risk
of electric shock!
Initial use
Before starting to use the product, make
sure that all preparations are made in
accordance with the instructions in sections
"Important safety instructions" and
"Installation".
To prepare the product to do the
•
dishes, perform first operation in the
shortest programme with detergent
while the machine is empty. During the
initial use, fill the salt reservoir with 1
litre of water prior to filling it with salt.
A
There might be a small amount
of water left in the product
after factory quality control
tests. This has no harm on the
product.
11 / 44 EN
Advertisement
Table of Contents
