Connection To The Drain - Beko BDIS38120A User Manual

Installation
Permitted water temperature:
up to 25°C ( 60°C for products
equipped with Aquasafe+; please
refer toAquasafe+ section )
The dishwasher may not be connected to
open warm water devices or flow-through
water heaters.
Do not use old or used water inlet
•
hose on the new product. Use the new
water inlet hose supplied with the
product.
Connect the water inlet hose directly
•
to the water tap. Pressure coming
from the tap should be minimum 0.3
and maximum 10 bars. If the water
pressure exceeds 10 bars, a pressure
relief valve should be installed in
between.
Open the taps completely after making
•
the connections to check for water
leaks.
C
Use a screw-on hose connector
to connect the water inlet hose
to a water tap with a ¾ inch
external thread. If required, use
a filter insert to filter deposits
from the pipes.
A
For your safety, close the water
inlet tap completely after the
washing programme is over.

Connection to the drain

Water discharge hose can directly be
10 /44 EN
connected to the drain hole or sink's drainage.
The length of this connection must be min. 50
cm and max. 100 cm from the floor. A discharge
hose longer than 4 meters causes dirty
washing.
Attach the water discharge hose to the
drainpipe without bending it. Tightly fix the
water discharge hose to the drainpipe in
order to prevent any dislocation of the water
discharge hose during operation of the product.
C
Drainpipe must be connected
to the sewage system and it
should not be connected to any
surface water.
Aquasafe+
(depends on model)
The Aquasafe+ system protects against water
leaks that may occur at the hose inlet.Water
contact with the valve box of the system must
be avoided to prevent damage to the electrical
system. If the Aquasafe+ system is damaged,
unplug the product and call the Authorised
Service Agent.
A
As the hose set contains
electrical connections and
assemblies, never shorten
or lengthen the hose with
extension hoses.
Dishwasher / User's Manual
* mm