Jeep COMPASS 2019 User Manual page 74

WARNING!
• When in "Partial Off" mode, the TCS
functionality of ESC, (except for the lim-
ited slip feature described in the TCS
section), has been disabled and the "ESC
Off Indicator Light" will be illuminated.
When in "Partial Off" mode, the engine
power reduction feature of TCS is dis-
abled, and the enhanced vehicle stability
offered by the ESC system is reduced.
• Trailer Sway control (TSC) is disabled
when the ESC system is in the "Partial
Off" mode.
Full Off (Four-Wheel Drive Models Only)
This mode is intended for off-highway or
off-road use when ESC stability features
could inhibit vehicle maneuverability due to
trail conditions. This mode is entered by
pushing and holding the "ESC Off" switch for
five seconds when the vehicle is stopped and
the engine is running. After five seconds, the
"ESC OFF Indicator Light" will illuminate and
the "ESC OFF" message will appear in the
instrument cluster display.
72
In this mode, ESC and TCS, except for the
"limited slip" feature described in the TCS
section, are turned off until the vehicle
reaches a speed of 40 mph (64 km/h). At
40 mph (64 km/h), the system returns to
"Partial Off" mode, as described above. TCS
remains off. When the vehicle speed drops
below 30 mph (48 km/h), the ESC system
shuts off. ESC is deactivated at low vehicle
speeds so that it will not interfere with off-
road driving however, ESC function returns to
provide the stability feature at speeds above
40 mph (64 km/h). The "ESC OFF Indicator
Light" will always be illuminated when ESC is
off.
To turn ESC on again, momentarily push the
"ESC Off" switch. This will restore the "ESC
On" mode of operation.
NOTE:
The "ESC OFF" message will display and an
audible chime will sound when the gear se-
lector is placed into the PARK position from
any other position, and then moved out of the
PARK position. This will occur even if the
message was previously cleared.
WARNING!
In the "Full Off" mode, the engine torque
reduction and stability features are dis-
abled. In an emergency evasive maneuver,
the ESC system will not engage to assist in
maintaining stability. "ESC Off" mode is
intended for off-highway or off-road use
only.
ESC Activation/Malfunction Indicator Light
And ESC OFF Indicator Light
The "ESC Activation/Malfunction
Indicator Light" in the instrument
cluster will come on when the
ignition is turned to the ON mode.
It should go out with the engine
running. If the "ESC Activation/Malfunction
Indicator Light" comes on continuously with
the engine running, a malfunction has been
detected in the ESC system. If this light
remains on after several ignition cycles, and
the vehicle has been driven several miles
(kilometers) at speeds greater than 30 mph
(48 km/h), see an authorized dealer as soon
as possible to have the problem diagnosed
and corrected.