Jeep COMPASS 2019 User Manual page 122

WARNING!
be badly injured or killed. Follow the
child restraint manufacturer's directions
exactly when installing an infant or child
restraint.
• Child restraint anchorages are designed
to withstand only those loads imposed
by correctly-fitted child restraints. Un-
der no circumstances are they to be used
for adult seat belts, harnesses, or for
attaching other items or equipment to
the vehicle.
Installing Child Restraints Using The
Vehicle Seat Belt
Child restraint systems are designed to be
secured in vehicle seats by lap belts or the
lap belt portion of a lap/shoulder belt.
WARNING!
• Improper installation or failure to prop-
erly secure a child restraint can lead to
120
WARNING!
failure of the restraint. The child could
be badly injured or killed.
• Follow the child restraint manufactur-
er's directions exactly when installing an
infant or child restraint.
The seat belts in the passenger seating posi-
tions are equipped with a Switchable Auto-
matic Locking Retractor (ALR) that is de-
signed to keep the lap portion of the seat belt
tight around the child restraint so that it is
not necessary to use a locking clip. The ALR
retractor can be "switched" into a locked
mode by pulling all of the webbing out of the
retractor and then letting the webbing retract
back into the retractor. If it is locked, the ALR
will make a clicking noise while the webbing
is pulled back into the retractor.
Refer to the "Automatic Locking Mode" de-
scription in "Switchable Automatic Locking
Retractors (ALR)" under "Occupant Re-
straint Systems" for additional information
on ALR.
Please see the table below and the following
sections for more information.
Lap/Shoulder Belt Systems For Installing
Child Restraints In This Vehicle
Automatic Locking Retractor (ALR)
Locations
ALR — Switchable Automatic Locking
Retractor
Top Tether Anchorage Symbol