Advertisement
QUICK START GUIDE
Slide the wheel arms out from above (Figure 13) and reinstall the wheels right
side up (Figure 14). Adjust the retaining cap so it can now sit on the top of the
wheel after being installed right side up. Apply a drop of the provided thread
locker onto the set screw threads before reinstalling into the retaining cap.
Make sure the set screw is properly seated in the groove at the top of the wheel
arm. DO NOT over-tighten the set screws as this will compress the screw against
the arm and prevent the wheel from being able to pivot.
2022-1.0
Figure 12
IBEX EQUIPMENT CO
Advertisement
