Advertisement
QUICK START GUIDE
Cut and remove the banding and zip ties holding the hay stop, box of parts, and
PTO shaft (Figure 2 & Figure 3).
Figure 2
Remove the hay stop guard arm and side guard panels (Figure 4 & Figure 5).
These are secured to the pallet via wood screws and washers. Then place them
to the side.
Figure 4
Remove the lag bolts that are holding the main three point hitch in place (Figure
6). Then cut the banding holding the back of the belt rake frame (Figure 7).
2022-1.0
Figure 3
Figure 5
IBEX EQUIPMENT CO
Advertisement
