Advertisement
Preparation
Loading the fabric in the tray
For details, refer to User's Guide provided with the printer BT-12.
You can shorten the processing time by putting a garment in the tray while preheating the
finisher.
➊
Press the [Power] key to turn on the power..
➋
Make sure the mode switching lever is set in the
center.
➌
Set the temperature of the heater.
Set the temperature according to the fabric on which
you are printing. The default setting is "High"
Procedure for (
➊
When you move the mode switching lever to the
left, processing starts. An alarm sounds after pre-
heating is completed.
➋
➍
Set the amount of time that the heater is on.
Set the time according to the fabric on which you
are printing. The default setting is "Medium".
➎
When the [Preheat] key is lit, press the [Preheat]
key to start preheating.
When the [Preheat] key is unlit, no operation is
necessary because preheating is completed.
)
Procedure for (
➊
When you move the mode switching lever to the
right, processing starts. An alarm sounds after
preheating is completed.
➋
© 2018 Roland DG Corporation
Printed in Japan
EN GB
EN US
EN AU
R1-181105 FA01418
)
J089-7032
Advertisement
