Replacing The Power Cable; Disposal And Recycling; Cleaning And Maintenance - EINHELL TE-ID 650 E Original Operating Instructions

Anleitung TE_ID_650_E_SPK8__ 11.09.12 15:33 Seite 20
GB
7.7.4 Drilling in tiles
To start the hole, switch the drill / hammer drill
n
selector switch (3) to position A (drill).
Switch the drill / hammer drill selector switch (3)
n
to position B (hammer drill) as soon as the drill bit
has passed through the tiles.

8. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or qualified electrician to avoid danger.

9. Cleaning and maintenance

Always pull out the mains power plug before starting
any cleaning work.
9.1 Cleaning
Keep all safety devices, air vents and the motor
n
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
down with compressed air at low pressure.
We recommend that you clean the equipment
n
immediately after you use it.
Clean the equipment regularly with a damp cloth
n
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the
plastic parts in the equipment. Ensure that no
water can get into the interior of the equipment.
The ingress of water into an electric tool
increases the risk of an electric shock.
9.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important. The carbon brushes should not be
replaced by anyone but a qualified electrician.
9.3 Servicing
There are no parts inside the equipment which
require additional maintenance.
9.4 Storage
Store the equipment and accessories in a dark, dry
and place above freeing temperature and not
accessible to children. The ideal storage temperature
is between 10 und 30 °C.
20

10. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.