¡
¢
[Fig. 1]
[Fig. 2]
[Fig. 3]
[Fig. 4]
10
Thread Take-up Lever Clearance
Loosen the screw
for the face plate and disassemble the face
plate.
Remove the rubber cap from the arm hole. Insert the driver to
loosen the screw
for the thread take-up lever hinge pin by
turning it full circle.
Be cautious not to turn the cutting part of the screw for
the thread take-up lever hinge pin.
Smoothly press the tread take-up lever hinge pin
of the arm bed and tighten the screw
Slightly move the thread take-up
clearance.
in the direction
for the hinge pin.
left and right to check the