Specifications - Makita DUR194ZX2 Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Model:
Type of handle
No load speed
Overall length
(without cutting tool)
Nylon cord diameter
Applicable cutting tool and
cutting diameter
Rated voltage
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Recommended cord connected power source
Portable power pack
• The cord connected power source(s) listed above may not be available depending on your region of residence.
• Before using the cord connected power source, read instruction and cautionary markings on them.
Noise
8-tooth blade
Nylon cutting head
Plastic blade
• Even if the sound pressure level listed above is 80 dB (A) or less, the level under working may exceed 80 dB
(A). Wear ear protection.
8-tooth blade
(P/N 191Y44-2)
Nylon cutting head
(P/N 198893-8, 191D89-4)
Plastic blade
(P/N 191Y45-0)
Cutting tool
BL1815N / BL1820B / BL1830B / BL1840B / BL1850B / BL1860B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF /
Sound pressure level
(L ) dB(A)
pA
L dB(A) Uncer-
pA
tainty (K)
dB(A)
73.5 2.9
72.6 2.6
75.8 0.7
10 ENGLISH
DUR194
Loop handle
-1
2: 6,000 min
-1
1: 4,500 min
1,580 mm
2.0 mm
200 mm
280 mm
230 mm
D.C. 18 V
2.6 - 2.9 kg
DC18SH / DC18WC
PDC01
Sound power level (L
WA
dB(A)
L dB(A) Uncer-
WA
tainty (K)
dB(A)
88.6 2.9
85.3 3.0
86.2 2.5
) Applicable
standard
ISO22868
(ISO11806-1)
ISO22868
(ISO11806-1)/
EN50636-2-91
ISO22868
(ISO11806-1)/
EN50636-2-91