Table of Contents
Advertisement
2-1 Control Panels
2-1-1 Upper Control Panel
1 POWER
switch
2 Level meters
dB
dB
dB
0
0
0
POWER
-10
-10
-10
ON
-20
-20
-20
-30
-30
-30
-40
-40
-40
OFF
-80
-80
-80
PHONES
CH-1
CH-2
CH-3
PB
PULL FOR VARIABLE
DISPLAY
CH-1
CH-2
CH-3
FULL/FINE
4 PB controls
5 DISPLAY FULL/FINE switch
6 PHONES jack and control
1 POWER switch
This powers the unit on and off. When the unit is
powered on, the level meters 2 and the fluorescent
display in the lower control panel light.
To power the unit off, press the side of the POWER
switch marked "OFF".
2 Level meters
These show the audio playback levels of channels 1 to
4.
There are two modes for audio level indications:
FULL and FINE, selected by the DISPLAY FULL/
FINE switch 5.
3 AUDIO MONITOR SELECT buttons
Press the buttons in the L and R rows to select the
audio signal channels output from the MONITOR
OUTPUT L and MONITOR OUTPUT R connectors.
You can press two or more buttons simultaneously in
each row, turning them on, to monitor an output
produced by mixing the selected channels.
2-2
Chapter 2 Location and Function of Parts
dB
0
-10
-20
-30
-40
-80
CH-4
CH-4
7 Time code setting section
8 REMOTE buttons and
3 AUDIO MONITOR SELECT buttons
Cassette compartment
DIGITAL
TC
AUDIO MONITOR SELECT
LTC
CH-1
CH-2
CH-3
CH-4
AUTO
L
VITC
R
RS-232C indicator
4 PB (playback) controls
These adjust individually the playback levels on
channels 1 to 4.
During playback, pull out the control knobs and adjust
the level while monitoring the audio level indication
on the level meters 2.
When the control knobs are pushed in, the playback
levels return to the preset levels, and cannot be
adjusted.
5 DISPLAY FULL/FINE switch
This switches the audio level meter 2 display as
follows:
FULL: The display covers the range – 60 dB to 0 dB
or – 40 dB to +20 dB as selected using extended
menu item 806.
In this mode the segment of the display
corresponding to the current audio level and all
lower segments light.
FINE: The display is enlarged, with a step of 0.25
dB. A segment indicating the reference level
lights.
In this mode only the segment of the display
corresponding to the current audio level lights. If
the audio level exceeds the maximum display
level, the top segment flashes, and if the audio
level goes below the minimum display level, the
bottom segment flashes.
REMOTE
1(9P)
DF
2(50P)
NDF
RS-232C
Advertisement
Table of Contents
