Upper Control Panel - Sony MSW-A2000P Operation Manual

2-1 Control Panels

2-1-1 Upper Control Panel

1 POWER switch
2 REMOTE buttons and RS-232C indicator
REMOTE
POWER
1(9P)
PHONES
5 PHONES jack and control
1 POWER switch
Pressing the ' ) ' side of the switch powers the unit on.
When the unit is powered on, the audio setting display
section (see page 2-5) and the time data/menu display
section (see page 2-7) light.
2 REMOTE buttons and RS-232C indicator
Press one of these buttons to select the device
controlling this unit.
1(9P): This unit is controlled by the device connected
to the REMOTE 1-IN(9P) or REMOTE 1-
OUT(9P) connector. The button lights.
2(50P): This unit is controlled by the device
connected to the REMOTE 2 PARALLEL I/
O(50P) connector. The button lights.
RS-232C indicator: This indicator lights when this
unit is controlled through the RS-232C connector.
3 EJECT button
To eject the cassette, press this button. While the
cassette is being ejected, this button lights.
When using the lower control panel as remote control
panel, press the DELETE button and STOP button at
the same time to eject the cassette.
Note
Ejecting with the EJECT button is a local operation. It
is not possible to eject a cassette in another unit by
remote control.
2-2
Chapter 2 Location and Function of Parts
3 EJECT button
4 Format indicators
BETACAM/SP BETACAM SX MPEG IMX
EJECT
2(50P) RS-232C
Z
Cassette compartment
Digital BETACAM
4 Format indicators
a)
The BETACAM/SP , BETACAM SX, MPEG IMX,
or Digital BETACAM
the current recording or playback format.
The BETACAM/SP indicator lights when the format is
Betacam or Betacam SP.
a) The MSW-2000 does not have the Digital BETACAM
and BETACAM/SP indicator.
b) The MSW-A2000/A2000P does not have the Digital
BETACAM indicator.
5 PHONES jack and control
Connect stereo headphones with an impedance of
8 ohms, to monitor the sound during recording,
playback and editing.
The control knob adjusts the volume.
It is possible to set an internal board switch so that the
output volume from the MONITOR OUTPUT L and R
connectors is controlled simultaneously.
For details, refer to the Installation Manual.
b)
indicator lights depending on