The Rear Panel - TP-Link TL-WR1043ND User Manual

Quick Flash
Note:
After a device is successfully added to the network by QSS function, the QSS LED will keep on for
about 5 minutes and then turn off.

1.4.2 The Rear Panel

The following parts are located on the rear panel (View from left to right).
POWER: The Power socket is where you will connect the power adapter. Please use the
power adapter provided with this TL-WR1043ND Wireless N Gigabit Router.
RESET：
There are two ways to reset to the Router's factory defaults:
1) Use the Factory Defaults function on System Tools -> Factory Defaults page in the
Router's Web-based Utility.
2) Use the Factory Default Reset button: With the Router powered on, use a pin to press
and hold the Reset button (about 5 seconds) until the SYS LED becomes quick-flash
from slow-flash. And then release the button and wait the Router to reboot to its factory
default settings.
USB: Connect with USB Mass Storage Device.
WAN: This WAN port is where you will connect the DSL/cable Modem, or Ethernet
1,2,3,4 (LAN): These ports (1, 2, 3, 4) connect the Router to the local PC(s).
TL-WR1043N/TL-WR1043ND
A wireless device failed to be added to the network by QSS
function.
Table 1-1 The LEDs Description
Figure 1-2 Rear Panel sketch
- 5 -
Wireless N Gigabit Router