Note:
1.
After a device is successfully added to the network by WPS function, the WPS LED will keep
on for about 5 minutes and then turn off.
2.
The router is set to work concurrently in 2.4GHz and 5GHz by default. If you desire to choose
the working frequency, please go to
1.4.2
The Rear Panel
The following parts are located on the rear panel (View from left to right).
WPS/Reset:
Pressing this button for less than 5 seconds enables the WPS function. If your client devices,
such as wireless adapters, support Wi-Fi Protected Setup, press this button to quickly
establish a WPA secure connection between the client devices and the router.
Archer C20
4.5 Dual Band
Figure 1-2 Rear Panel sketch
- 5 -
AC750 Wireless Dual Band Router
Selection.