Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for TP-Link TL-SG1008D
Summary of Contents for TP-Link TL-SG1008D
- Page 1 TL-SG1008D 8-port Gigabit Desktop Switch REV: 1.0.0 1910010024...
-
Page 2: Fcc Statement
COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP- LINK TECHNOLOGIES CO., LTD. -
Page 3: Ce Mark Warning
CE Mark Warning This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. SAFETY NOTICES Cautions Do not use this product near water, for example, in a wet basement or near a swimming pool. Avoid using this product during an electrical storm. -
Page 4: Package Contents
Package Contents The following items should be found in your box: One TL-SG1008D 8-port Gigabit Desktop Switch One AC Power Adapter This User Guide Note: Make sure that the box contains the above items. If any of the listed items are damaged or... -
Page 5: Table Of Contents
1.1 Overview of the Product... 1 1.2 Convention... 1 1.3 Features... 1 Chapter 2. Installation... 2 2.1 Mounting the Switch on a Desk... 2 2.2 Power On ... 2 Chapter 3. Identifying External Components... 3 3.1 Front Panel ... 3 3.2 Rear Panel ... -
Page 6: Chapter 1. Introduction Of The Product
Gigabit speed. The TL-SG1008D switch is very easy to manage since it is plug-and-play and no configuration is needed. In addition, the auto MDI/MDI-X cable detection on all ports eliminates the demand of crossover cable or Uplink port. -
Page 7: Chapter 2. Installation
Please avoid any heavy thing placed on the switch. 2.2 Power On TL-SG1008D 8-port Gigabit Desktop Switch can be used with AC power supply. Powering on the Switch, it will automatically initialize and its LED indicators will respond as follows:... -
Page 8: Chapter 3. Identifying External Components
The Power socket is where you will connect the power adapter. Please use power adapter provided with this TL-SG1008D Switch. Port (1- 8): The TL-SG1008D Switch is equipped with 8 10/100/1000Mbps Auto-Sensing RJ45 ports where you will connect your network devices. The working status can be indicated by the corresponding LEDs on the front panel. -
Page 9: Appendix A: Specifications
Appendix A: Specifications General Standards Topology Protocol Data Transfer Rate Network Media(Cable) Number of Ports LED indicators Transfer Method MAC Address Learning Frame Filter Rate Frame Forward Rate Environmental and Physical Dimensions(W×D×H) Power Supply Output Operating Temperature Storage Temperature Operating Humidity Storage Humidity IEEE802.3, IEEE802.3u, IEEE802.3ab Star... -
Page 10: Appendix B: Troubleshooting
Appendix B: Troubleshooting The Power LED is not lit Check to see if the AC power cord is connected to the Switch properly, and make sure the power source is ON. The Link/Act LED is not lit when a device is connected to the corresponding port Check to see if the cable connectors are firmly plugged into the Switch and the device, and verify the connected device is turned on and working well.