Specifications; Troubleshooting - FujiFilm instax mini Link 3 User Manual

Specifications

Recording method 3-color exposure with OLED
Film used FUJIFILM INSTAX MINI Instant Film (sold
separately)
Image size 62 mm × 46 mm
Exposure pixel 800 × 600 dots
count
Exposure resolution 12.5 dots/mm (318 dpi, 80 μm dot pitch)
Exposure gradation RGB gradation of 256 colors
Interface Bluetooth Ver. 5.1
Printable image JPEG, PNG, HEIF, DNG
format
Printing time Approximately 15 sec.
Possible number of Approximately 100 (from full charge;
printed images number of prints depends on the usage
conditions.)
Power supply Lithium-ion battery (internal type: not
removable)
Charging time Approximately 1.5 to 2.0 hours
(depending upon environment
temperature at time of charging)
Power consumption Approximately 3 W
Operating Temperature: +5°C to +40°C
environment Humidity: 20% to 80% (no condensation)
Dimensions 90.0 mm × 37.3 mm × 125.0 mm
(excluding projecting parts)
Weight 210 g (excluding film cartridge)
Supplied accessory USB Type-C cable (FZ00013220, Length:
30 cm)
*The above specifications are subject to change for performance
improvement.
14

Troubleshooting

Please check the following items before considering the problem
to be a malfunction. If the problem persists even after taking
action, please contact the FUJIFILM service center for repair in your
country or visit the website below:
FUJIFILM website: https://www.fujifilm.com/
If the following problem occurs���
Problem Possible causes and solutions
I cannot turn the • The battery may not be charged. Please
printer on. charge the printer.
• You did not press the power button for
long enough. Press and hold the power
button for approximately 1 second.
The battery If you use the printer in a very cold
loses its charge environment, the battery will drain quickly.
quickly. Please keep the printer warm before
printing.
The printer The battery level may be low. Please charge
shuts down the printer.
during use.
Charging does Make sure that the USB power adapter plug
not start. is properly connected to the power outlet.
The printer takes At low temperatures, charging may take
too long to longer.
charge.
Charging stops Charge the battery in a temperature range of
during charging. +5 °C to +40 °C. If you cannot charge the
printer in this range, contact your FUJIFILM
dealer or support center.
The printer does • There may be a temporary malfunction.
not function Please press the reset button. If the printer
normally. still does not function normally, please
contact our repair service center for repair.
• The battery may not be charged. Please
charge the printer.
The film • Please use FUJIFILM INSTAX MINI Instant
cartridge does Film (other films cannot be used).
not load or does • Align the yellow mark on the film
not load cartridge with the yellow alignment
correctly. marker on the printer body, once aligned
load the film into the printer.
The film does • The film may be misaligned due to an
not eject. impact such as vibration or dropping.
Please load a new film cartridge.
• If the film is jammed, turn the printer off
and turn it on again. If the problem
persists, remove the jammed film and
then load a new film cartridge.
Some or all of Do not open the film door until the film has
the finished been used up. If the film door is opened with
prints are white. film remaining, the film will be exposed and
become white.