Page 1
24V2Q VESA adapter Assembly instructions The VESA adapter is compatible with the following AOC (aoc.com) products: 24v2q, 27v2q The VESA adapter allows you to conveniently mount your AOC brand monitor to a monitor arm with a VESA hole pattern (75 x 75mm). Use the included screws and nuts.
Assembly instructions Important Safeguards Please read these instructions carefully and keep them for future reference. If you pass the product on to third parties, these instructions should always be included. Failure to follow these instructions may result in injury or damage to persons or the product, for which we cannot accept any liability.
For the disposal of this product we recommend to contact the responsible local authorities or disposal services. They can provide you with detailed information on available disposal options and recycling centers in your area. 4. Manufacturer Information 3idee Technologies S.à r.l. 5 Um Lenster Bierg L-6125 Junglinster Luxembourg 5.
Assembly instructions Horizontal / Vertical Alignment Please note: Not all VESA adapters and monitors are designed for vertical (upright) orientation. This limitation is often due to the specific geometry of the adapter or monitor. Do not ignore this information, as the load limit of the adapter can quickly be exceeded if not installed properly. We are continuously working on developing monitors and adapters that are also suitable for vertical orientation.
Assembly instructions Assembly Instruction Step 1 Remove the lower part of the base of your AOC monitor. (Figure 1) Figure 1 Step 2 Check whether the square nut is still in the correct position. This step is already taken care of in our production, but it may happen that the square nut falls out during longer transports by a shipping service provider.
Page 7
Alternative: Wall mounting is also possible, but screws and dowels are not included. Figure 3 Step 4 Now you can "slide" your AOC monitor onto the 3idee VESA adapter. Of course, you can determine the height yourself. (Figure 4) Figure 4...
Page 8
Assembly instructions Step 6 Now comes the small part of the 3idee bracket and the thumbscrew. (Figure 6) This looks as shown and is in the product packaging. Figure 6 Step 7 Now attach the "clamp" from step 6 to the 3idee VES adapter so that it holds your screen in place (Figure 7).