ETC OneTrack Backbone End Feed Housing Installation Manual

ETC Installation Guide
OneTrack Backbone End Feed Housing
Overview
OneTrack Backbone End Feed Housing is an enclosure for the OneTrack End
Feed when used with OneTrack Backbone.
Separate installation and wiring instructions are provided with the End Feed.
For information on planning a complete OneTrack system, see the OneTrack
by ETC and OneTrack Backbone System Planning and Installation Manual
available for download at etcconnect.com/OneTrack.
Installation
Tools required: #2 Phillips screwdriver, 15 mm socket wrench, and 8 mm socket wrench for
knockout
1. Remove the side panels of the End Feed Housing. Retain
the side panels and hardware for later reattachment.
2. Slide the End Feed Housing into the OneTrack Backbone.
3. Secure the top portion of the End Feed Housing to the
OneTrack Backbone using the attached bolt.
Corporate Headquarters n Middleton, WI, USA | +1 608 831 4116
Global Offices n London, UK | Rome, IT | Holzkirchen, DE | Paris, FR | Hong Kong | Dubai, UAE | Singapore
New York, NY | Orlando, FL | Los Angeles, CA | Austin, TX | © 2023 Electronic Theatre Controls, Inc.
Web
Trademark and patent info:
Product information and specifications subject to change. ETC intends this document to be provided in its entirety.
7076M2140 Rev A Released 2023-06
etcconnect.com | Support support.etcconnect.com
etcconnect.com/ip
Slide End Feed
Housing into
Backbone
| Contact etcconnect.com/contactETC
| Third-party license agreement info: etcconnect.com/licenses
OneTrack Backbone
End Feed Housing
Remove side panels
Tighten bolt
to secure