Table of Contents
Advertisement
Display assembly
Full hinge-up displays are not spared. Displays are spared only at the subcomponent level.
Before removing the display panel, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the optical drive (see
3.
Remove the bottom cover (see
4.
Remove the battery (see
Remove the display assembly:
1.
Lift the tape from the display connector on the system board (1).
2.
Disconnect the cable from the connector (2).
3.
Remove the cable from the clip (3).
4.
Remove the four Phillips M2.5 × 6.0 screws (1) from the display hinges.
5.
Remove the Phillips broad head M2.0 × 2.0 screw (2) from the right display hinge.
6.
Rotate the hinges upward (3).
54
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
(Preparation for disassembly on page
Optical drive on page
Bottom cover on page
Battery on page
34).
29).
32).
28).
Advertisement
Table of Contents
