Brushed Motor Setup - GRAUPNER S2003 Operating Instruction

The optional accessory
Connection configuration for the ESC, Motor, Battery, and Wire splitter
For the connections on the charger side terminal, the connector marked "sensor in the wire
splitter" is connected to the motor and the left 2 connectors are connected to the charge
and the ESC, respectively. The ESC signal connector is connected to the charge servo test
socket.
33
Wire splitter for testing the motor
sensor (S8002)

Brushed motor setup

Connect the motor to a 4mm banana charge socket. Tap the MOTOR icon to access the motor
setup mode. This page has 3 menus.
1) Break-In
- The motor is operated and limited by the preset voltage for the preset time.
The operating time is set by minutes and seconds
The operating voltage is set.
Tap the Enter button to check the operating time, volt-
age, and consumption current.
2) Program
- Programming requires 4 inputs: the voltage, the operating time, the delay time and the
number of cycles. After entering each data value, tap the Enter button. The charger will
repeat to load the motor using the preset number of cycles. The blue character shows the
current process.
34