Table of Contents
Advertisement
6.4.8 Removing the Keypad
Unplug the encoder cable and unscrew the three PT3×8 screws indicated below. Remove
the keypad.
6.4.9 Removing the Encoder
Pull the knob off the encoder shaft. Remove the retaining nut. Then remove the encoder.
Knob
6.4.10 Removing the Alarm Lamp
Unscrew the four PT2×6 screws indicated below and remove the alarm lamp board and
alarm lamp.
6-19
Encoder
shaft
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Accutor 7 and is the answer not in the manual?