Xpwnnnnn - Shutdown Wait Time (*); Xponnnnn - Power-Off Time (*); Xpunnnnn - Power-Up Delay (*) - Sferalabs Strato Pi Base Advanced Configuration Manual

Command Description
XPEI When ShutdownEnable is set to high, Strato Pi will immediately
initiate the power-cycle, wait 60 seconds (configurable with
XPWnnnnn) and then power off the Pi board for at least 5
seconds (configurable with XPOnnnnn) (factory default)
XPEA Setting ShutdownEnable high will arm the shutdown procedure,
but will not start the power-cycle until ShutdownEnable goes low.
After the line goes low, Strato Pi will wait 60 seconds
(configurable with XPWnnnnn) and then power off the Pi board
for at least 5 seconds (configurable with XPOnnnnn)
XPE? Return current shutdown enable mode

XPWnnnnn - shutdown wait time (*)

Set the shutdown wait time, in seconds.
Command Description
XPWnnnnn Set the shutdown wait time, in seconds (factory default is 60,
XPW00060). Min: 1; Max: 99999
XPW? Return current shutdown wait time

XPOnnnnn - power-off time (*)

Set the power-off time, in seconds.
Command Description
XPOnnnnn Set the power-off time, in seconds (factory default is 5,
XPW00005). Min: 1; Max: 99999
XPO? Return current power-off time

XPUnnnnn - power-up delay (*)

Set the power-up delay, in seconds.
After being powered off, the Strato Pi board will supply power to the Raspberry Pi (or
release the reset line of Raspberry Pi Compute Module) only when the main power source
is restored for at least the number of seconds set with XPUnnnnn, or immediately (factory
default) if the power-on delay is set to 0.
Command Description
XPUnnnnn Set the power-up delay, in seconds (factory default is 0,
XPU00000). Min: 0; Max: 99999
XPU? Return current power-up delay
8
Reply
XPEI
XPEA
XPEn
Reply
XPWnnnnn
XPWnnnnn
Reply
XPOnnnnn
XPOnnnnn
Reply
XPUnnnnn
XPUnnnnn
Strato Pi Logic Controller