Xsd1N - Sd1 Enable (*); Permanently Saving The Current Configuration; Xccn - Persistent Configuration; Firmware Version Information - Sferalabs Strato Pi Base Advanced Configuration Manual

Command Description
XSD01 enable SDX (RA5 = H) (factory default)
XSD00 disable SDX (RA5 = L)
XSD0? return SDX enable status

XSD1n - SD1 enable (*)

Immediately enable/disable the SD1 interface (RC0).
Command Description
XSD11 enable SD1 (RC0 = H)
XSD10 disable SD1 (RC0 = L) (factory default)
XSD1? return SD1 enable status
Permanently saving the current configuration
The configuration parameters corresponding to commands marked with (*) are retained
only until the next power-cycle, unless persisted in memory. If not persisted, the
parameters will be reset to the original factory defaults, or to the previously saved user
configuration.
Note: the Strato Pi controller's permanent memory can only accept up to 100.000 writes
throughout the component's lifetime.To prevent damaging the memory the XCCS and
XCCR commands should be executed with a frequency such as to avoid exceeding the
maximum number of total memory writes.

XCCn - persistent configuration

Permanently save the current configuration as the new factory default, or restore the
original factory settings.
Command Description
XCCS Permanently save the current configuration as the new factory
default
XCCR Permanently restore the original factory settings

Firmware version information

XFW? - read firmware version

Returns the firmware version.
14
Reply
XSD01
XSD00
XSD0n
Reply
XSD11
XSD10
XSD0n
Reply
XCCS
XCCR
Strato Pi Logic Controller