Table of Contents
Advertisement
Description
The SaniForce Heater is an electric heating system to
heat fluids in ultra-high purity (sanitary) environments.
This heating system may be used with aggressive
fluids, such as deionized water or acids, while
maintaining the purity of those process fluids.
Typical Installation
D
A
F
. 1: Horizontally Mounted Typical Installation
IG
Key:
A
Fluid inlet port
B
Fluid outlet port
C
Electrical wiring port
D
Flexible, conductive fluid inlet line
E
Flexible, conductive fluid outlet line
3A8940A
H
G
E
J
General Information
•
Typical installations are shown in F
The figures are only guides for selecting and
installing system components. Contact your Graco
distributor for assistance in planning a system to
suit your needs.
•
Always use genuine Graco parts and accessories.
•
Reference numbers and letters in parentheses refer
to the callouts in the figures.
F
H
E
C
B
D
F
. 2: Vertically Mounted Typical Installation
IG
F* Thermocouple wire
G
Pressure relief valve (required, not supplied)
H
Fluid shutoff valve (required, not supplied)
J
Fluid drain valve (required, not supplied)
*
Connect to a temperature controller (not shown;
required, not supplied).
Description
. 1 and F
IG
F
C
G
B
J
A
. 2.
IG
7
Advertisement
Table of Contents
