Tesla PC401W User Manual page 5

DRAWING FOR THE STRUCTURE
1. Back panel
2. Control panel
3. The knob control temperature
4. Waterproof switch
5. Front panel
6. Wheels
ASSEMBLE INSTRUCTION AND USING AREA
1. Before use:
A. The heater should be placed on a smooth solid plate or grounded, then insert the socket.
(Warning: Requires outlet and cable: AC220-240V, 50Hz, 10A with grounding - cable required.
B. Do not insert the cable before installing the wheels Install the wheel as shown in Figure G (1) Fix the hook
and bracket as shown in Figure G(2) (no need to install wheels)
Requirement of using area for wall-hanging type: The heater should be more than 200mm higher based on
the floor,and should consider of the space around carefully,the distance between the heater and the object
should be more than 200mm at side,and 500mm at front,and 500mm at top,also the distance between
the heater and the wall at side less than 200mm is forbidden,between the ceiling less than 500mm is
forbidden. So than the air around can convect effectively,and heat up evidenty.
Pay more attention on the distance between the heater and objects, and it's forbidden to install the heater
under the socket. The heater have IPX4 IP rating , all technology submit to safety standard, and can install it
in any room, also in bath room.
If install the heater in the bathroom, we suggest installing the heater in a place where couldn't be touched.
Hook
Plastic screw
Screw
Bracket
5