To Light The Burners - Carbest 70178 User Instruction

EN
CARBEST Gas Cooker l 70178-70181 / 70183 / 70557-70559 / 70561-70563 / 70567-70569
To fully understand this booklet, check which model you have just purchased.
Each model has:
• tempered glass hob; above each knob, a diagram indicating the burner to which the knob refers;
• 1/2/3 burners. Each burner consists of: metal cover; aluminium fame divider resistant to high temper-
atures (PYRAL); stainless steel heat shield flange with built-in pan stand; heat-sensitive element (safety
cut-off switch).
• plastic knobs;
• pan restraint column, to fit into the appropriate position to guarantee the stability of the pans. To order.

2. To light the burners

make sure that the gas main is open. Press and turn the burner knob anticlockwise to the maximum (big
flame) position, as shown in figure 1. These position is easily recognised by a small mechanical stop. At this
point, approach the flame with a lit match or electric lighter and press the knob down. Keep the knob
pressed for a few seconds, then release it. This operation is necessary to activate the gas safety device (cut-
off switch). This is a thermo-electric device which guarantees the cut-off of the gas supply in a few seconds if
the flame accidentally goes out.
When the burner is lit, turn the knob to the minimum position (small flame, figure 1), then place the con-
tainer on the pan stand.
Turn the knob to the required flame intensity.
Should the flames accidentally go out, turn the burner control knob off and wait at least 1 min before at-
tempting to light it again
NOTE: To switch off the burner, turn the knob clockwise to align the index with the off position
(solid spot ● or empty dot ○ ).
When the appliance is not in use, make sure that the knobs are always in the off position.
Should the rotation of the control knob become stiff, contact the Technical Assistance as soon as possible.
Do not attempt to reset or dismantle the hob.
Fig.1
18