Maintaining The Hardware; Maintaining The Fabric - Dometic 9200 Series Operating Instructions Manual

9200 Series Power Awning

5 .1 Maintaining the hardware

q
w
11 Lubricating fabric roller tube assembly
Silicone spray
q
1. Apply silicone spray lubricant as needed to the
moving parts on the fabric roller tube assembly.
12 Lubricating arm assemblies
2. Lubricate all pins and sliding surfaces of the arm
assemblies with silicone spray, as needed.

5 .2 Maintaining the fabric

NOTICE: Do not use abrasive or corrosive cleaners,
mildew removers, or hard bristle brushes on the awning
fabric. Failure to obey this notice could result in damage
to the awning or other property.
I Vinyl awning fabric is durable and water resistant.
Wrinkling is a normal characteristic, which may be
more noticeable when the awning is retracted,
and after prolonged periods of stowage (rolled
up). Leave the awning open during warm weather
to minimize wrinkling. A slight "travel line" may
appear where the door roller (if installed) contacts
the fabric. This is normal and does not affect the
integrity of the fabric.
EN
Fabric roller tube assembly
w
13 Cleaning awning fabric
To clean the fabric:
1. Open the awning.
2. Mix 2 fl oz (59 ml) dish soap and 2 fl oz (59 ml) bleach
with 5 gal (19 L) of fresh water.
3. Liberally drench the fabric with cleaning solution.
4. Close the awning and allow the cleaning solution to
soak for five minutes.
5. Open the awning and thoroughly hose off the top
and bottom of the fabric with clean water. Repeat if
necessary.
6. Remove the solution completely from the awning
fabric.
Bleach will degrade the fabric if it is not
I
completely rinsed off.
7. Make sure the fabric is dry before closing the awning.
Maintenance
9