Operation - Bresser NATIONAL GEOGRAPHIC 9110550 Operating Instructions Manual

EN
Rules of metal detection
1. Regulations for using metal detectors vary internationally. Be sure to check the local rules and laws
before you start.
2. Respect private property and do not enter without the owner's permission.
3. Never destroy historical or archaeological objects.
4. If you are not sure whether you have found an object, contact a museum or historical society near you.
5. Be sure to fill in all holes and try not to leave any damage.
6. Remove and dispose of any rubbish and litter found.

Operation

1. Your metal detector comes completely assembled. You only need to install the battery (not included) in
the metal detector.
2. To adjust the length, turn the locking ring located on the shaft of the metal detector counter-clockwise.
3. Adjust to desired length and position the coil to be flat to the ground while in use.
4. Turn the locking ring clockwise to lock the length of the shaft to desired position.
5. To adjust the length of the metal detector to a smaller unit, loosen the locking rings and position the
head close to the handle.
Using your metal detector:
Before powering on the device position the metal detector so the search coil is away from any metal ob-
jects. Then turn the unit on by moving the toggle on the device away from you. You will see a green light
showing the power is turned on. Your unit is self-calibrated and needs no further adjustment. Your metal
detector is ready to be used in the most sensitive detection setting.
correct
wrong
To search for metal objects, swing the metal detector back and forth slowly while keeping the search coil
level and approx. 2 cm above the ground. When your metal detector locates a metal object it will start to
emit a tone. The more solid and louder the tone, the stronger the signal, which indicates how close the
object is to the coil. Your unit also has an signal light that will illuminate when the signal strength is strong.
By using both the signal light and the signal tone you will be able to discover many amazing things just
below ground.
During the search, the LCD display shows [ ]. When the detector finds a metallic object, the red LED
lights up. A beep sounds and [ ] appears on the LCD display.
When the LCD shows [ ], you need to change the battery.
11