General Warnings; Operation; Scope Of Delivery - Bresser 9110500 Operating Instructions Manual

General Warnings

• Children should only use the device under adult supervision. Keep packaging material, like plastic
bags and rubber bands, out of the reach of children, as these materials pose a choking hazard.
• Not suitable for children under 3 years!
• RISK of property damage — Do not disassemble the device. In the event of a defect, please contact
your dealer. The dealer will contact the Service Centre and can send the device in to be repaired, if
necessary.
• RISK of ELECTRIC SHOCK — This device contains electronic components that operate via a power
source (batteries). Children should only use the device under adult supervision. Only use the device
as described in the manual; otherwise, you run the risk of an electric shock.
• RISK OF CHEMICAL BURN — Keep batteries out of the reach of children! Make sure you insert the
batteries correctly. Empty or damaged batteries could cause burns if they come into contact with the
skin. If necessary, wear adequate gloves for protection.
• RISK of FIRE/EXPLOSION! — Do not expose the device to high temperatures. Use only the
recommended batteries. Do not short-circuit the device or batteries, or throw them into a fire.
Excessive heat or improper handling could trigger a short-circuit, a fire or an explosion.
• Use only the recommended batteries. Always replace weak or empty batteries with a new, complete
set of batteries at full capacity. Do not use batteries from different brands or with different capacities.
Remove the batteries from the unit if it has not been used for a long time.
• Never use rechargeable batteries.
• The manufacturer is not liable for damage related to improperly installed batteries!

Scope of delivery

Metal detector, LED light, Instruction manual
Insert batteries
Battery Requirements:
1x Alkaline battery (9V) for Metal detector (not included)
3x AAA batteries for LED light (not included)
Open the battery compartment with a screwdriver and follow the polarity information (+)(-) on the inside of the com-
partment. Do not force the battery into place with the polarity reversed because this can damage the item. Replace
the battery door and tighten the door with a screwdriver.

Operation

1. Your metal detector comes completely assembled. You only need to install batteries (not included)
in the metal detector and its led light.
2. To adjust the length, turn the locking ring located on the shaft of the metal detector counter-clock-
wise.
3. Adjust to desired length and position the coil to be flat to the ground while in use.
4. Turn the locking ring clockwise to lock the length of the shaft to desired position.
5. To adjust the length of the metal detector to a smaller unit, loosen the locking rings and position the
head close to the handle.
8