Rockwell Automation Integration; Automatic Diagnostic Aop Items - Panduit VeriSafe VS2-NET User Manual

Rockwell Automation Integration

The EtherNet/IP
from Rockwell Automation . The AOP supports the Automatic Diagnostics feature .
„

AUTOMATIC DIAGNOSTIC AOP ITEMS

REQUIREMENTS
„
„
CONNECTIVITY STATUS
WORD(2)
„
Table 6.
STATUS
DWORD(4)
„
Table 7.
1006819, B21176_EN_rev3
protocol is supplemented by an Add-On Profile (AOP) for easy integration with products
TM
AOP available in Studio 5000 Logix Designer V33 .01 or greater
Logix controller must be V33 or greater
Factory Talk View software must be V12 or greater
Sensor lead status is based on the last completed test . This value will only be updated when a test is
completed with no voltage present .
0
Connected L1
0: L1 Sensor lead
disconnected
1: L1 Sensor lead
connected
Status bits associated with the network module and AVT . This value will only be updated when an absence
of voltage test is completed .
0
Battery Warning Indicator AVT Temperature Fault AVT Internal Fault Network Module Fault
0: Battery OK
1: Check battery
(Battery low or not
present)
0: Battery OK
1: Check battery
Bit
1
Connected L2
0: L2 Sensor lead 0: L3 Sensor lead
disconnected disconnected
1: L2 Sensor lead 1: L3 Sensor lead
connected connected
Bit
1
0: OK
1: Fault
0: AVT temperature OK
1: AVT temperature
fault
24
2
Connected L3 Connected PE GND
0: PE GND Sensor lead
disconnected
1: PE GND Sensor lead
connected
6
0: OK 0: OK
1: Fault 1: Fault
0: AVT OK 0: Network module OK
1: AVT Internal
1: Network module fault
fault
3
7
06/19/2023