Appendix C: Installing Software Drivers And The Operating System - Supermicro X6DVL-iG2 User Manual

Appendix C: Software Installation
Appendix C
Installing Software Drivers and the
Operating System
After all the hardware has been installed, you must first configure the
Adaptec Embedded Serial ATA RAID Driver before you install the Windows
operating system. The necessary drivers are all included on the Supermicro
bootable CDs that came packaged with your motherboard.
C-1 Introduction to the Adaptec Embedded Serial ATA
RAID Controller Driver
Serial ATA (SATA)
Serial ATA(SATA) is a physical storage interface. It uses a single cable with
a minimum of four wires to create a point-to-point connection between
devices. It is a serial link which supports SATA Transfer rates from
150MBps. Because the serial cables used in SATA are thinner than the
traditional cables used in Parallel ATA(PATA), SATA systems have better
airflow and can be installed in smaller chassis than Parallel ATA. In addition,
the cables used in PATA can only extend to 40cm long, while Serial ATA
cables can extend up to one meter. Overall, Serial ATA provides better
functionality than Parallel ATA.
Introduction to the Intel 6300ESB I/O Controller Hub
Located in the South Bridge of the Intel E7320 Chipset, the 6300ESB I/O
Controller Hub provides the I/O subsystem with access to the rest of the
system. It supports 2-channel Ultra ATA/100 Bus Master IDE controller (PATA)
and two Serial ATA (SATA) Host Controllers, which support up to two Serial
ATA ports and up to two RAID drives.
*Note
( : All functionality, features and components related to the InfiniBand
are available for the X6DVL-INF only.)
C-1