Table of Contents
Advertisement
USING THE NINJA® DUALBREW
SPECIALTY COFFEE SYSTEM CONT.
INTEGRATED FROTHER
The Integrated Frother does not heat
milk.
1 Add milk to your cup until it is about 1/3
full.
• For cold froth, go to Step 2.
• For hot froth, microwave for
45-60 seconds.
NOTE: Frother does not heat liquid.
FOR HOT FROTH
2 Swing the arm of the frother toward
the front of the brewer. Install the
frother whisk by twisting it to the right.
3 Hold the cup under the frother and
submerge the whisk just below the
surface of the milk. Press and hold the
button on top of the frother and froth
for 20-45 seconds.
4 Remove the frother whisk by twisting
it to the left. Keep your cup below the
whisk while you carry it to your sink or
dishwasher for easy cleaning.
WARNING: To avoid contact with
steam and hot surfaces. DO NOT
reach across top of brewer to froth.
16 1-877-646-5288
CLEANING & MAINTENANCE
CLEANING AFTER A BREW
Dishwasher Safe Parts:
Permanent filter, brew basket, glass carafe
and brew-through lid, water reservoir and
lid, frother whisk, Ninja smart scoop, and
Ninja pod adapter.
Hand-Wash Only:
Sliding lid
1 After the brewer has cooled, remove
the brew basket. If using a paper
filter, discard it. If using a permanent
filter, discard the grounds and wash
thoroughly with soap and warm water.
If using pods, remove the Ninja Pod
Adapter and brew basket. Wash the
used parts thoroughly with soap and
warm water.
2 Clean the frother whisk after each use.
Hand-wash thoroughly or place on top
rack of dishwasher.
3 Wash the carafe and brew-through lid
with soap and warm water. Use a bottle
brush or cloth to wash the inside of the
carafe. DO NOT use a wire brush.
NOTE: For best results, we recommend
rinsing the reservoir after brewing and
refilling with fresh water for the next
brew.
CLEANING THE WATER RESERVOIR
Empty the reservoir and hand-wash or
place in dishwasher. For a better clean, we
recommend placing it in the bottom rack of
the dishwasher standing upright with the
opening facing downward. We recommend
doing this weekly.
CLEANING THE CARAFE
We recommend cleaning your carafe after
each use with warm, soapy water. or place
in the dishwasher.
To clean the carafe more thoroughly, we
recommend using a soft foam brush.
DO NOT use a wire brush.
CLEANING THE SLIDING LID
Open the hinged hood on top of the
brewer by pulling up on the left side. Once
opened, slide the sliding lid out of the
back of the brewer to remove it. Hand-
wash the sliding lid with warm, soapy
water. Slide the sliding lid back into its
tracks and close the hinged hood.
NOTE: DO NOT place the sliding lid in
the dishwasher.
CLEANING THE NINJA POD ADAPTER
Open the handle to reveal the needles and
pod holder and hand-wash with warm,
soapy water. Take care when cleaning
around the needles. Then, close the handle
and slide it back into the REMOVE position
before reinstalling.
CLEANING THE BREW BASKET
If brewing grounds, allow the brewer to
cool, then remove the brew basket by
pinching the handle and lifting straight up.
If using a paper filter, discard the filter by
dumping the brew basket upside down
into a waste-bin. If brewing pods, first
remove and discard the used pod, then
remove the Ninja Pod Adapter and wash
the brew basket.
CLEANING & DESCALING YOUR
BREWING SYSTEM
Your Ninja DualBrew coffee maker offers
two modes to choose from, Grounds and
Pods. Each mode that you use will eventually
need to be cleaned with a clean cycle.
The clean cycle is used for descaling
the brewer when calcium scale buildup
is affecting the performance of the
brewer and/or the flavor of your coffee.
The Intelligent Clean Cycle Indicator will
automatically illuminate orange when a
cleaning cycle is recommended for your
brewer. If the indicator is ignored, your
brewer may stop mid-brew and display
"CLn," indicating it needs immediate
cleaning on the current mode.
NOTE: The clean cycle takes
approximately 90 minutes.
ninjakitchen.com
17
Advertisement
Table of Contents
