Cleaning Your Water Reservoir; Cleaning The Frother - Ninja CF112 Series Owner's Manual

8
Continue dispensing water until the water delivery cycle
stops, the machine beeps, and the CLEAN light flashes
FIVE times.
9
Empty and thoroughly clean the container and water
reservoir to remove any cleaning solution that could
affect the flavor of your coffee.
10 Fill the reservoir with fresh water up to but not
exceeding the Max Fill line (30 oz.) and set the
container beneath the brew basket.
11 Press the CLEAN button again to begin Flush cycles.
Each Flush cycle takes approximately 10 to 15 minutes.
12 At the end of each Flush cycle, your Ninja Coffee Bar will
beep and the CLEAN light will flash three times. Empty
the container and set it under the brew basket again.
13 Press the CLEAN button again to begin another Flush
cycle. At the end of each cycle, your Ninja Coffee Bar
will beep and the CLEAN light will flash three times.
14 Continue running Flush cycles until water delivery
stops, the machine beeps, and the CLEAN light flashes
FIVE times.
Fig. 19
15 After flushing, the CLEAN light will turn off. Discard the
water in the container and any water remaining in the
reservoir.
NOTE: If the CLEAN light illuminates again, then
calcium buildup is still present. Repeat the steps above
and the CLEAN light will automatically shut off when
your Ninja Coffee Bar is clean.
Please call Customer Service at 1-877-646-5288 to
purchase descaling solution or if the brewer needs any
servicing.

CLEANING YOUR WATER RESERVOIR

1 Empty the water reservoir.
2
Hand wash with dish soap and rinse, or place on the
top rack of your dishwasher.
3
Clean the water reservoir shelf with cloth and warm
soapy water.

CLEANING THE FROTHER

1
Separate Frother Whisk from Arm
Handwashing: Wash the Frother Whisk in warm soapy
water. Handle Frother Whisk with care.
Dishwasher: The Frother Whisk is dishwasher safe.
Please place on top rack of dishwasher.
16
ninjacoffeebar.com