How To Use The Elliptical - NordicTrack NTEL99421-INT.2 User Manual

HOW TO USE THE ELLIPTICAL

HOW TO PLUG IN THE POWER ADAPTER
IMPORTANT: If the elliptical has been exposed to
cold temperatures, allow it to warm to room tem-
perature before you plug in the power adapter (A).
If you do not do this, you may damage the console
displays or other electronic components.
IMPORTANT: Always plug the power adapter (A)
into the elliptical before you plug it into an outlet.
Plug the power
adapter (A) into the
receptacle on the
front of the elliptical.
Insert the appropri-
ate plug adapter
into the power
adapter if neces-
sary. Then, plug the
power adapter into
an appropriate outlet that is properly installed in accor-
dance with all local codes and ordinances.
HOW TO MOVE THE ELLIPTICAL
Due to the size and weight of the elliptical, moving
it requires two persons. Take any necessary
measures to avoid damaging your floor.
First, loosen the
upright knob (B).
Next, pull the
upright knob, and
pull the upright
(C) in the direction
shown by the arrow
until the latch (D)
stops the upright.
Then, release the
upright knob.
A
C
D
B
9
Next, push the
upright (C) in the
opposite direction
slightly, lift the latch
(D), and then lower
the upright to the
folded position.
Hold the upright
in one of the
indicated loca-
tions (E) while you
lower the upright;
do not hold the
upper body arms.
Next, hold the handle (F) on the front stabilizer and lift
the elliptical until it will roll on the wheels (not shown)
on the rear stabilizer. Then, carefully move the elliptical
to the desired location, and lower it to the floor.
When you are finished moving the elliptical, lift the
upright (C) to the vertical position and tighten the
upright knob (B).
E
C
D
C
F
B