Table of Contents
Advertisement
If there is a problem with your appliance, please check the following points before
contacting your local Fisher & Paykel trained and support service technician or the
Customer Care Center.
Product parts and accessories can be purchased through Fisher & Paykel Customer Care
Center or online at fisherpaykel.com (this service is available to selected markets only).
PROBLEM
Appliance does
not operate
Interior light
and/or control
panel not
working
Motor operates
for long periods
Unfamiliar
noises coming
from appliance
Slides not
extending fully
Drawer panel
not sitting flush
with cabinetry
22
TROUBLESHOOTING
POSSIBLE CAUSES
No electricity at
power outlet.
Power cord not
attached at the rear
of appliance.
No electricity at power
outlet.
Sabbath mode may
be activated.
Light not functioning.
Key Lock mode may
be activated.
Note: This is normal. This appliance uses an energy efficient variable
speed compressor that saves energy by running for long periods
of time on a low speed. This is more energy efficient than the
conventional on/off method.
Freezer is defrosting.
Refrigerant noises,
eg cracking, popping,
hissing, running water,
humming.
Drawer skin not fitted
or adjusted correctly.
WHAT TO DO
Check that the plug is correctly connected
to outlet and that power is switched on.
Check another appliance at the same outlet.
Check the house fuse.
Has the appliance just been installed?
Refer to your Installation instructions sheet
to ensure the installer signed saying the
product was working after installation
then call your Fisher & Paykel trained and
support service technician.
Check that appliance is connected to
power and is switched on.
Press
and
together for four seconds,
until icon disappears.
The light cannot be serviced by the user.
Contact your Fisher & Paykel trained and
supported service technician.
Press
for 3 seconds until the
goes out.
This is normal.
This is normal. Refer to 'User warnings and
sounds'.
Hold onto sides of drawer or tray, extend
the slides fully and evenly by using a firm
pull on both sides. This will reset the slides.
Adjust drawer skin. Refer to your
Installation instructions sheet.
icon light
Advertisement
Table of Contents
