Watch Dog Enable/Disable; Compact Flash Master/Slave; Sas Controller Enable/Disable - Supermicro SUPERSERVER 6014H-32 User Manual

Watch Dog Enable/Disable

JWD controls the Watch Dog function.
Watch Dog is a system monitor that
can reboot the system when a software
application hangs. Pins 1-2 will cause
WD to reset the system if an applica-
tion hangs. Pins 2-3 will generate a
non-maskable interrupt signal for the
application that is hung up. See the
table on the right for jumper settings.
Watch Dog must also be enabled in
BIOS. Note: When enabled, the user
needs to write their own application
software in order to disable the Watch
Dog Timer.

Compact Flash Master/Slave

If you wish to use a Compact Flash
card in the IDE slot(s), you must assign
master or slave status to the slot(s) be-
ing used. JP17 assigns status to the
IDE#1 slot and JP18 assigns status to
the IDE#2 slot. See the table on the
right for jumper settings.
SAS Controller Enable
JPS1 enables or disables the Adapt-
ec 9140W SAS controller on the
serverboard. See the table on the
right for jumper settings. The default
setting is enabled.
Chapter 5: Advanced Serverboard Setup
Watch Dog
Jumper Settings (JWD)
Jumper Setting
Pins 1-2
Pins 2-3
Open
Compact Flash Master/Slave
Jumper Settings (JP17/JP18)
Jumper Setting
Open
Closed
SAS Controller Enable
Jumper Settings (JPS1)
Jumper Setting
Pins 1-2
Pins 2-3
5-19
Defi nition
Reset
NMI
Disabled
Defi nition
Slave
Master
Defi nition
Enabled
Disabled